A
Anonymous
Guest
I recently purchased a CVA Wolf from Muzzleloaders.com. I have shot almost 30 rounds of Powerbelt aerolite 250grain ammo through it. I tried about 12 rounds of Blue MZ pellets (100 Grains) some at 50 yards and then on out to 100, and then switched powder. I am now using (2) 777 50/50 pellets (100 grains) and Federal 209 Muzzleloader Primers. I am using a Nikon Prostaff 3x9x40 BDC. My first shot of the day will be within an inch of the target. I then clean the bore the same way every time. 1 swab/patch of CVA barrel cleaner followed by two dry patches followed by a little CLP oil followed by a dry patch. I then fire a 209 primer through it, load it back up and it will be high and to the left (4"-6")almost every time. I am trying to be consistent in doing the same exact thing every time. BUT that second shot is always way off. I tried eliminating the CLP oil and my groups still end up high and left.
I have even gotten a friend to shoot it with the same results, I was thinking it was a warm barrel issue then changed my between shot cleaning procedure and as I mentioned eliminated the CLP, I got one good shot off then they started going high and left again???
Why is my first shot so good but every shot after that so bad?
This is all at exactly 100 yards (except the first few at 50 to get it close)
I have even gotten a friend to shoot it with the same results, I was thinking it was a warm barrel issue then changed my between shot cleaning procedure and as I mentioned eliminated the CLP, I got one good shot off then they started going high and left again???
Why is my first shot so good but every shot after that so bad?
This is all at exactly 100 yards (except the first few at 50 to get it close)