Here's the setup:
CVA Accura MR Nitride with Blackhorn breachplug
90g Blackhorn powder
CCI 209 shotgun primer
Hornady FBP 300g
The issue:
Out of a four shot sequence, one of the shots will have the breach not want to open and that primer will be discolored by what I'm assuming to be blow back. All of the other primers come out and look clean. Out of the same 4 shot group, I'll have a flyer but haven't correlated the burnt primer to the flyer, will look at that the next range session. Also have noted that the firing pin is not hitting the primer dead center, upon inspection it looks like the firing pin is a little bent but I'm wary of trying to straighten it.
Any advice?
CVA Accura MR Nitride with Blackhorn breachplug
90g Blackhorn powder
CCI 209 shotgun primer
Hornady FBP 300g
The issue:
Out of a four shot sequence, one of the shots will have the breach not want to open and that primer will be discolored by what I'm assuming to be blow back. All of the other primers come out and look clean. Out of the same 4 shot group, I'll have a flyer but haven't correlated the burnt primer to the flyer, will look at that the next range session. Also have noted that the firing pin is not hitting the primer dead center, upon inspection it looks like the firing pin is a little bent but I'm wary of trying to straighten it.
Any advice?