I just cast these of Certified PURE Lead from BACO, They are SHARP, Mirrors of the Mold 
They measure .452 on the Dot
Those look great!
Dems sum purty boolats. I be liken dem fo twelbs tu.
Nice metplat without jumping all the way upto the 460s.
Now all it be needen is a hollar point in it.
That is basically the bullet i wanted to try from Bullshop. He has a old mold for a 405ish gr hollow point. Its so old i cant find any good pics of it.
45 Caliber ~ Lee Moulds ~ .457 ~ 405 grains ~ HP
I found a old catalog pic online but cant find a pic of the finished bullet. I can see if i can dig up the part# again.
Think this was it
I think Lew’s 412L mould as a HP would make and be a better bullet!
I just sent Erik Ohlen an Email about Hollow Pointing my Mold with his “inset bar” setup But ONLY if he can do it, and stil allow me to Cast them Solid as well. Depending on his Response? My mold might be headed to Oregon for Awhile 
With the renewed interest in 45s its just about perfect IMO. Dont need to shoot no wiz bang $2.50 per shot loads. A bullet like that will kill nearly anything with hooves without killing you shooting it. The HP will just help a bit as it slows down for longer shots. That bullet should shoot in dem new imported fo tee fibes just fine and they dont need some sissy skirt to do it.
I would even buy 50 or 100 of dem boolats because im so sure its more than likely a winner.
I’m just waiting on his email Back to me
Ouch! wish i could say that hurt my feelings but ... nope, nothing.That bullet should shoot in dem new imported fo tee fibes just fine and they dont need some sissy skirt to do it.
