You just said a mouthfull right there !!! We BETTER let This one Soak In . Absolutely Fabulous Lewis !!!!!!I agree with Flounder on the .506, I am not Familiar with the White Bores? Aren’t they a True .504? If so, a .506 Would be a GOOD Way to go.
Accurate Bullet molds is my Favorite outfit, his Steel Molds are my ABSOLUTE FAVORITE Bullet Molds!! I just copied Accurate's Tolerances here, and added .506 as example. Make sure you Read and understand this!
I want an "as cast" diameter as close as I can get to .506".
I have a diameter tolerance window of .002" for my molds.
When ordering a diameter such as .506", you can select:
- Positive tolerance (+.002/-.000) means the diameter will be AT LEAST .506" But could be as much as .508
- Negative tolerance (+.000/-.002) means the diameter will be AT MOST .506" but could be as small as .504
- Centered tolerance (+/- .001) means as close as possible to .506" Could be .505, .506, .507
Positive tolerance is usually desirable for driving bands.
Negative tolerance is usually best for bore ride noses or any application where a certain diameter cannot be exceeded and a sizing die won't be used on that portion of the bullet.
Centered tolerance might be desirable when powder coating, and tapered designs.
Using "Special Notes" on the online order form, you can refine your diameter request for bore ride, body diameter, whatever, to the 4th decimal place. Ordering to the half thousandth does not ensure precision to the half thousandth, it only helps you communicate the desired diameter range within that .002" window.
My mold cavities are actually turned to +/-.0001" tolerance, but I cannot guarantee resultant casting tolerance closer than .002" because of casting variables such as pour technique and temperature, mold block temperature, purity of alloy, etc.
It IS hard to measure a slugged bore bullet. The portion that rides the lands is smaller than the portion that rides the grooves and you can get several different measurements around it. I have several different home made sizing dies, I made on the lathe that I punch my bullets through. I bore them .001 under, then sand until they drop a bullet exactly the size I want. I want them to fit so that they push in a clean barrel with light thumb pressure, insuring they will be slightly snug on a fouled bore, but push down with light to moderate pressure on the ramrod. Three of my .504 Whites are all different. My Whitetail is right at .504, one of my Super 91”s is .about 5055 and the other Super 91 is about .5075!!!! Notice I said about, I’m adding .0005” to the size of bullet that fits the barrel how I like it. My Whitetail is blued, my two Super’s stainless. My .451 seems to be dead on .451. I have one other Whitetail that I purchased on Gunbroker that I haven’t really played with much yet. It doesn’t shoot .503 NoExcuses worth a dang, but they seem to load right, so I’m guessing it’s pretty close to .504. I’m guessing the breech plug is toast. I have seen a huge change in accuracy by changing out the plugs.On ebay or pawn shops you sometimes see Small Hole Gauges for sale . Machinist tools . With these tools you can Easily measure the land to land of most any popular bore size whether home or at a dealer or a show . They have a "ball" end and a knob to adjust the fit as each hemisphere expands or contracts . Bring along a micrometer or dial caliper and you got ACCURATE measurements . Apply as needed........
Much more versitile than slugging .
Enter your email address to join: