- Joined
- May 19, 2005
- Messages
- 171
- Reaction score
- 0
ok i put my action back in the stock with screws not even snug then holding rifle vertical butt down then i give it a sharp rap (6in or so to seat the recoil lug) then i tighten front screw to 15in-lb then the rear to 15 in-lb then 20in-lbs front and rear and then to 25 in-lb three times in the same pattern using a snap-on dial torqueometer that is 0-100 in-lbs model and as of yet no POI changes any other ideas? so how does everyone else do it? :shock: