I recently bought a NOS Knight Extreme 45 cal. This week the bare primer from Knight was installed and today I did some shooting. On the positive side there is less blowback than the original red DISC set up. On the negative, the primers are kinda hard to load into the new bolt and won't release after they are fired, without some prying and/or bolt removal. From what I have read on the forum if I add shims to the bp primer pocket this should improve the fit and release of the primer. So I roughly measured the shims needed and it is .015-.020 . I need to do a little more work on this variance. So that is the story and here is the related question, about this new breach plug.....it has a vent liner. Does the vent liner need to be removed as part of the cleaning process or removed periodically or just left alone until it needs replaced? Thanks for any advice.
Also on the plus side I got a load figured out of 105gr triple 7ffg with 200gr XTP. I think this is going to be the hunting load for year 1 with a ml.
Also on the plus side I got a load figured out of 105gr triple 7ffg with 200gr XTP. I think this is going to be the hunting load for year 1 with a ml.