- Joined
- May 19, 2005
- Messages
- 3,880
- Reaction score
- 3,312
I swapped a scope that I had on one of my ML with the same brand ML. I returned the adjustments for both windage and elevation to Zero and mounted the scope. I bore sighted it as best as I could, yet at the range at 25 yds, I was shooting about 6" high. I tried adjusting the elevation to lower it but I ran out of clicks and I'm still about 3 inches high at 25yds. The only difference while using the same manufacturer Rings (Warne) is I went from Low to Medium rings.
Any suggestions before I take everything off again and try again is appreciated.
Any suggestions before I take everything off again and try again is appreciated.