- Joined
- Jan 11, 2019
- Messages
- 638
- Reaction score
- 171
I went out this morning to try 2 different bullets in my New Knight Mountaineer .45 Cal 1:20 Twist, One of my Favorite Paper Patch Bullets that i have been Shooting for Several years, i have shot this exact same bullet to 500 Yards in my 1:30 Twist GM LRH Barrel in a TC Hawken Stock, With Peep Sights. I have turned out some impressive Groups over the last few years with this Particular Bullet, I started Shooting this Bullet not long after i Started shooting Muzzleloaders, This Bullet FLAT OUT Shoots! This morning’s go around proved no different in this New Knight Mountaineer 1:20 Twist. If i were a competitive Shooter i would NO DOUBT Shoot these against ANY Bullet out there, BRING IT ON! These things will hang with ANYTHING!!
<iframe width="560" height="315" src="https://www.youtube.com/embed/Fb9DtcGAF_w" frameborder="0" loading="lazy" allowfullscreen ></iframe>
The Bullet after i Patch them, I short patch these. I get these Bullets by the Box of 50 from Buffalo Arms, they are a Swaged Cupped Base Bullet, .444-400 (.444 Diameter, 400 Grains) Quality Control with these is IMPECCABLE, The majority will weigh to the 10th of a Grain of eachother (Again, they are Swaged, NOT CAST)
If i do my part, this little Bullet will do it’s :Red tup:
The little 300 Grain Grease Groove Bullet was a NO GO, It played out about like i figured it would, But i needed to know for sure. NO DOUBT i could get this MUCH better, but this was just me wanting to Tinker around with something Different. I have MUCH Better Bullets, And Several of them for this Particular Rifle, and Rate of Twist.
<iframe width="560" height="315" src="https://www.youtube.com/embed/Fb9DtcGAF_w" frameborder="0" loading="lazy" allowfullscreen ></iframe>
The Bullet after i Patch them, I short patch these. I get these Bullets by the Box of 50 from Buffalo Arms, they are a Swaged Cupped Base Bullet, .444-400 (.444 Diameter, 400 Grains) Quality Control with these is IMPECCABLE, The majority will weigh to the 10th of a Grain of eachother (Again, they are Swaged, NOT CAST)
If i do my part, this little Bullet will do it’s :Red tup:
The little 300 Grain Grease Groove Bullet was a NO GO, It played out about like i figured it would, But i needed to know for sure. NO DOUBT i could get this MUCH better, but this was just me wanting to Tinker around with something Different. I have MUCH Better Bullets, And Several of them for this Particular Rifle, and Rate of Twist.