Hi,
I recently purchased a T/C Encore 50 cal. I have wanted one for a long time. I have not shot it yet, but have dry fired it and measured the trigger weight. It's pretty heavy at about 5 pounds I think. I also noticed that the hammer is significantly difficult to pull back which I find suprising. Mine has the hammer spur that can rotate to the right or left to prevent interference with a scope.
I have seen a couple of places online where they do action and trigger jobs for the TC. Can anyone recommend one to me? Which one do you think is the best route to go?
Also does the "action" job include smoothing out the hammer to enable easier cocking and perhaps the barrel latch as well which also seems a bit "stiff" to me when I open the bore.
thanks
Matt
I recently purchased a T/C Encore 50 cal. I have wanted one for a long time. I have not shot it yet, but have dry fired it and measured the trigger weight. It's pretty heavy at about 5 pounds I think. I also noticed that the hammer is significantly difficult to pull back which I find suprising. Mine has the hammer spur that can rotate to the right or left to prevent interference with a scope.
I have seen a couple of places online where they do action and trigger jobs for the TC. Can anyone recommend one to me? Which one do you think is the best route to go?
Also does the "action" job include smoothing out the hammer to enable easier cocking and perhaps the barrel latch as well which also seems a bit "stiff" to me when I open the bore.
thanks
Matt