- Joined
- May 19, 2005
- Messages
- 9,205
- Reaction score
- 1,741
C Broad Arrow
Another question for you... Does your Omega have the composite black stock? if so you might want to look at this information - that I wrote several years ago... And all of this is just my opinion.
To reinforce the stock lug pockets in the black synthetic stocks - I also created a block to insert between the blocks.
Another question for you... Does your Omega have the composite black stock? if so you might want to look at this information - that I wrote several years ago... And all of this is just my opinion.
The Omega… A weakness is the black synthetic stock supplied with the gun. The same black stock is provided from the less expensive Z5 model to the more expensive Stainless steel models.
The weaknesses of this stock’ IMO, are the flexible forearm and the shallow recoil lug pockets in the stock. In fact you should inspect these lug pockets each time you take your rifle down for cleaning. These pockets can crack and will allow the barreled action to move on recoil, TC will warranty your stock if these cracks appear. Another thing you should look for in your stock is a polish mark(s) along the barrel channel in the stock. If these marks are appearing, that is the point at which the barrel is making heavier contact with the stock than other places and will cause the POI to move.
It is my opinion that I would prefer a barreled action that fits snugly in the stock with equal pressure on all points along the barrel, in other words fully bedded or a heavier stock that will not flex. This is expensive for a manufacturer to do when producing mass production rifles so for them the least expensive alternative is to produce stocks that provide a free floating barrel.
Normally when you purchase a synthetic Omega the barreled action will fit somewhat snugly in the stock. It will not remain that way over time and even though it might seem snug it is not equal.
There really is not a lot we can do about the flexibility of the stock especially in the forearm, but there are things that can be done to reduce its effects of the forearm pushing on the barrel.
The easiest fix is to float the barrel, move the barrel from contact with the barrel channel in the stock. One of the time tested ways of checking “floating” is to slide a dollar bill under the barrel from the fore-end back to the receiver, leave the ram rod in place.
To float the barrel – in my mind to methods one is much simpler than the other but really both are on the easy side.
Method #1… Simply shim the barreled action up in the stock. I did this for a couple of seasons before I moved to the second easy step. Place a shim in the recoil lug pocket this will lift the action up and cause the barrel to lift in the stock. I made my shims from one of my wife’s Teflon cutting sheets. It is the perfect thickness, and everyone knows the durability of Teflon. Cut the shim to fit snugly in the bottom of the lug pocket punch a hole in the center of the shim for the lug bolt and install the barreled action. You should now be able to easily slide the dollar bill to slide under the barrel to the action. NOTE: because the pockets are so shallow I would not lift the action any higher than the thickness of one of these shims, and I suggest the reinforcement of the lug pockets as discussed later.
Method #2… Sand the barrel channel to fit the barrel. This is not as easy as it sounds but start by sanding the polished marks out of the barreled channel. As you remove these pressure points they will be replaced by other pressure points along the barrel. You will then continue to sand out points until the barrel sits snugly in the stock along its length, and further shooting does not cause further polished points.
Another simple fix you might consider… Look at the recoil pockets in the stock. It is a very simple fix to reinforce the lug pockets. This fix will stop the possible front to back movement of the action and probably stop the cracking of the pockets. I would suggest that you fill the area between the pockets with a fiberglass.
To reinforce the stock lug pockets in the black synthetic stocks - I also created a block to insert between the blocks.