Good evening,
Today I took out my CVA WOLF to verify my zero was still good. I loaded my BH 209, seated my bullet, and loaded my primer. Closed the gun, cocked the hammer, and my problems started. The hammer was hard to cock, but once cocked I could pull the trigger, as it seemed the trigger was stuck in the rear position. I tried lowering hammer by riding it while pulling trigger, but still got no movement with the trigger. Has anyone seen this issue before? What was the remedy? Anyone have any ideas? I would like to get this taken care of, as it is a safety issue.
Thanks in advance,
Dee
Today I took out my CVA WOLF to verify my zero was still good. I loaded my BH 209, seated my bullet, and loaded my primer. Closed the gun, cocked the hammer, and my problems started. The hammer was hard to cock, but once cocked I could pull the trigger, as it seemed the trigger was stuck in the rear position. I tried lowering hammer by riding it while pulling trigger, but still got no movement with the trigger. Has anyone seen this issue before? What was the remedy? Anyone have any ideas? I would like to get this taken care of, as it is a safety issue.
Thanks in advance,
Dee