Should fit. Maybe not reversed tho. I just took the rail off of my 45/70 and put it on an Optima pistol.Will it fit a 45-70 centerfire barrel?
I have DNZ Game Reapers on my CVA Accura V2 (275 grain Bloodline bullets/110 grains BH 209/1,951 fps), CVA Scout 445 SuperMag/44 Mag (210 grain CEB Maximus/2,187 fps), and on my CVA Scout 444 Marlin (250 grain CEB Maximus/2,441 fps). They have worked flawlessly for me.Yeah I got the DNZ but I have not installed it yet. I will report back once I get several shots through it.
Tom
Made in error.Yeah I got the DNZ but I have not installed it yet. I will report back once I get several shots through it.
Tom
My base looks like the one above. It has the part # as the one below. They don't look the same to me. One has the cantilever and one doesn't. I'm I missing something here????Picked up a Talley Rail, great fit to my MR-X 45cal. Much longer than the original. You can also reverse.
I got the Talley Picatinny rail for CVA (P00252006) and it fit my new Optima V2 well. I reversed it from what Stevie posted and had to use medium Warne rings so the bell cleared with the setback I needed without having to remove the rear sight.
In the pic you posted, I didn't see the cantilever. It looks like it's a solid base for its full length. If I mount my base like Stevie. The gun wouldn't close and the cantilever part would be too long. The hammer would hit the base.The front of the base that I mounted does not sit flush with the barrel. There is a small gap between the barrel and the rail just like in your picture but it is on the other end.
If I was to get a rail this be the one I’d pick up. Especially for anything before the x seriesI got the Talley Picatinny rail for CVA (P00252006) and it fit my new Optima V2 well. I reversed it from what Stevie posted and had to use medium Warne rings so the bell cleared with the setback I needed without having to remove the rear sight.
Enter your email address to join: