Hi Everyone, I am new here and new to muzzleloading. I recently bought a CVA .50cal Hawken caplock. It is in pretty good looking condition, but I have not shot it yet. I bought a replacement lock with engraving to make it look a little dressed up. I had a little trouble with the lock as it had a boss around the front screw hole. I had the boss removed so it is flat and got the lock installed. However, another problem appeared. The hammer and nipple do not line up properly. See attached pictures. I also noticed the bolster screw is stripped, as I tried to remove it to see if the bolster could be rotated a bit to improve the alignment of the hammer/nipple. I did NOT strip it, it was like that. I couldn't get it to budge by hand. My question is, how do I resolve the hammer/nipple alignment problem with this new lock?